How Many Quarts of Oil Does a 2014 Hyundai Elantra Take?

A 2014 Hyundai Elantra typically takes between 3.6 and 4.9 quarts of engine oil, depending on the engine and whether the oil filter is changed, with the most common 1.8L engine using about 4.2 quarts (4.0 liters) with a filter change. This article explains the exact capacities by engine type, why there’s a range, and how to confirm the correct amount for your specific car.

Understanding Oil Capacity for the 2014 Hyundai Elantra

The 2014 Hyundai Elantra was sold with more than one engine option, and each engine has a slightly different oil capacity. In addition, capacity is usually specified as one amount “with filter” and a slightly lower amount “without filter.” Because many owners search for a single number, confusion is common unless the engine and service scenario are clearly identified.

Oil Capacity by Engine Type

The 2014 Elantra line included a mainstream 1.8L engine found in most sedans, and 2.0L engines used in GT and Sport models. Each engine has its own oil capacity specification, which determines how much oil should be added during an oil change.

1.8L 4-Cylinder Engine (Most 2014 Elantra Sedans)

The 1.8-liter inline-4 (engine code often referred to as Nu 1.8L) is the most common engine configuration in the 2014 Elantra sedan sold in North America and many other markets.

The details below break down the typical oil capacity for this engine, which helps owners avoid underfilling or overfilling the crankcase during routine maintenance.

• With oil filter change: Approximately 4.2 quarts (about 4.0 liters).
• Without oil filter change: Typically closer to 3.6–3.8 quarts, because some oil remains trapped in the old filter.
• Recommended viscosity (most climates): Commonly 5W-20 or 5W-30 full synthetic or synthetic blend, depending on the manual and regional recommendations.

These figures mean that if you are doing a standard oil change and replacing the filter—which is what most service centers and DIY owners do—you should plan on having at least 4.2 quarts of oil available for a 1.8L 2014 Elantra and then verify the final level by dipstick.

2.0L 4-Cylinder Engines (Elantra GT and Elantra Sport Variants)

Some 2014 Elantra models—notably the Elantra GT and certain Sport-oriented trims—use a 2.0-liter inline-4. These engines can have a slightly larger oil capacity than the 1.8L unit, and capacities may vary slightly by regional specification or emission package.

The following points outline how the 2.0L engine’s oil requirement compares to the 1.8L, helping owners of GT or Sport models estimate the oil quantity they need.

• With oil filter change: Commonly in the range of 4.5–4.9 quarts (approximately 4.3–4.6 liters), depending on exact variant and market.
• Without oil filter change: Slightly less, generally around 4.0–4.3 quarts.
• Recommended viscosity (typical): Often 5W-20 or 5W-30, though this can vary by country and climate recommendations in the owner’s manual.

Because the 2.0L configurations are less common and can differ regionally, the best practice is to confirm the precise capacity in the owner’s manual for your VIN or consult a dealer database, then use the dipstick to fine-tune the final fill.

Why You See Different Numbers Online

Many car owners encounter multiple oil capacity numbers for the same model year online. This can usually be traced to differences in engine size, whether the filter is replaced, and rounding conversions between quarts and liters.

The list below highlights the main reasons capacities vary in different sources and why the factory specification may not match every generic chart you read.

• Engine differences: The 1.8L and 2.0L engines in the 2014 Elantra do not share identical oil capacities.
• Filter vs. no filter: Factory specs often list two numbers—one for oil change with filter, another without. Online summaries sometimes only quote one.
• Rounding from liters to quarts: Hyundai often publishes capacities in liters; when converted to quarts, numbers are rounded to one decimal place.
• Regional manuals: Manuals in North America, Europe, or Asia can show slightly different figures due to testing standards or emissions hardware.
• Aftermarket references: Parts-store databases or generic oil guides may use approximate figures that are close but not exact.

Because of these factors, the most reliable approach is to treat online numbers as a starting point, then rely on your vehicle’s dipstick and owner’s manual to confirm the final level.

How to Ensure You’re Adding the Right Amount

Even with published capacities, the safest method is to fill in stages and use the dipstick to verify. This protects your engine from potential damage due to overfilling or underfilling.

The following steps outline a practical way to complete an oil change on a 2014 Hyundai Elantra and accurately achieve the correct oil level.

1. Drain the oil completely: Warm the engine slightly, then shut it off, remove the drain plug, and let the oil drain until it slows to a drip.
2. Replace the oil filter: Install a new, correct-spec filter and lightly oil its gasket before tightening to the manufacturer’s specification.
3. Add most of the recommended capacity: For a 1.8L, start with about 4.0 quarts; for many 2.0L variants, start around 4.5 quarts, rather than pouring in the exact max figure right away.
4. Run the engine briefly: Start the car, let it idle 30–60 seconds, then shut it off. This allows oil to fill the filter and circulate.
5. Wait and check the dipstick: After a few minutes, check the dipstick on level ground. Wipe, reinsert, and confirm the level is between the “L” (low) and “F” (full) marks.
6. Top off in small amounts: Add oil in increments of about 0.1–0.2 quarts (100–200 ml) until the level reaches near the upper mark without going past it.

By following this method, you use the published capacity as a guideline but rely on the dipstick to fine-tune, which is the best safeguard against overfilling and ensures the engine operates within its intended lubrication range.

Practical Takeaways for Owners

For everyday owners, the key information is how much oil to buy and how to avoid common mistakes. Being prepared with the correct quantity and type of oil saves time and reduces the chance of problems after an oil change.

The points below summarize the most actionable guidance for a 2014 Hyundai Elantra oil change, especially if you are purchasing supplies or planning a DIY service.

• If you have a 1.8L sedan, expect to use about 4.2 quarts of oil with a filter change.
• If you have a 2.0L GT or Sport, plan for roughly 4.5–4.9 quarts, and verify the exact figure in your manual.
• Buy at least a 5-quart jug of the correct viscosity oil; this covers all normal scenarios and leaves a small amount for topping off.
• Always replace the oil filter when doing an oil change; capacities are generally listed assuming a new filter.
• Use the dipstick as the final authority after filling; do not rely solely on the number from a chart or article.

Keeping these points in mind ensures that, regardless of engine type or minor capacity variations, you will have enough oil on hand and can accurately set the level to protect the engine over the long term.

Summary

A 2014 Hyundai Elantra’s oil capacity depends on its engine and whether the filter is changed. The most common configuration—the 1.8L 4-cylinder sedan—typically uses about 4.2 quarts (4.0 liters) of oil with a new filter. Elantra models equipped with a 2.0L engine, such as some GT and Sport trims, generally require between 4.5 and 4.9 quarts. Because capacities can vary slightly by variant and region, the best practice is to use these numbers as a guide, consult your owner’s manual, and confirm the final level with the dipstick after filling.

How much oil does a 2.0 4 cylinder engine take?

Approximately 5.1 quarts
2.0L turbocharged engine: Approximately 5.1 quarts of oil.

How much oil does a Hyundai Elantra need?

approximately 4.2 quarts
For most 2025 and similar trims, the Hyundai Elantra oil capacity with an oil filter change is approximately 4.2 quarts (around 4.0 liters). Earlier model years, such as 2023, typically reference 4.5 quarts, although the brand’s newer engines trend toward the slightly lower fill.

How many quarts of oil does a 2014 Elantra take?

4.2 quarts
Pour in the specified amount of new oil. This should be about 4.2 quarts for the Hyundai Elantra, but you can find the exact amount in your owner’s manual. Replace the cap to your oil well.

How many quarts of oil does a 2.4 l Hyundai take?

5.1 quarts
Oil capacity: 5.1 quarts (4.8 liters) for 2.4L engine, 4.3 quarts (4.1 liters) for 2.0T engine.