How Much Oil a 2008 Honda CR‑V 2.4L Takes

The 2008 Honda CR‑V with the 2.4‑liter engine takes 4.4 US quarts (4.2 liters) of engine oil when the oil filter is replaced, or 4.2 US quarts (4.0 liters) if the filter is not replaced. Honda specifies 5W‑20 engine oil meeting current API standards; always verify on the dipstick after filling and adjust as needed.

Official Capacity and Specs

Honda’s published capacities for the third‑generation CR‑V (2007–2009) with the K‑series 2.4L engine cover two common service scenarios. The amount you’ll actually pour can vary slightly based on how long the oil is allowed to drain, the filter brand/size, and whether the vehicle is level during service.

Capacity breakdown

The following points outline the capacities you should plan for during routine maintenance.

• With oil filter change: 4.4 US qt (4.2 L)
• Without oil filter change: 4.2 US qt (4.0 L)

Most oil changes include replacing the filter, so expect to use about 4.4 quarts. If you buy a 5‑quart jug, you’ll typically have approximately 0.6 qt left over.

Recommended oil type and specification

Honda recommends 5W‑20 premium‑grade detergent oil that meets current API certification (today, API SP and ILSAC GF‑6 are suitable and backward‑compatible). Genuine Honda motor oil or any quality equivalent that meets these specs is acceptable.

While some owners use 0W‑20 in colder climates, the 2008 owner’s guidance is 5W‑20. If considering a different viscosity for extreme temperatures, consult the owner’s manual and local climate recommendations; capacity does not change with oil type.

How to Fill Correctly

Following a careful procedure helps you hit the correct level without overfilling and ensures proper engine lubrication after service.

1. Warm the engine briefly, then shut off and allow to cool so oil drains well but components aren’t too hot.
2. Drain the oil and replace the drain plug crush washer; reinstall and torque the plug properly.
3. Install a new oil filter; lightly oil the gasket and tighten by hand about 3/4 turn after gasket contact.
4. Add about 4.0 quarts initially, then start the engine for 30–60 seconds to circulate oil; shut off and wait a few minutes.
5. Check the dipstick on level ground and top up gradually to reach the upper mark; total will be near 4.4 quarts with a filter.
6. Recheck for leaks and verify the level again after a short drive.

This approach minimizes the risk of overfilling and accounts for small variations in drain time and filter volume.

Useful Torque and Part References

These common specs and parts notes apply to the 2008 CR‑V 2.4L and help ensure a leak‑free service.

• Drain plug torque: 29 lb‑ft (39 N·m)
• Drain plug crush washer: 14 mm aluminum (replace each service)
• Oil filter: OEM Honda filter for K‑series engines (e.g., 15400‑PLM‑A02) or equivalent; tighten by hand

Using a new crush washer and proper torque is essential to prevent seepage; hand‑tightening the filter prevents gasket damage while ensuring a proper seal.

Frequently Asked Clarifications

Owners often have related questions during oil service; here are concise answers to the most common ones.

• AWD vs. FWD capacity: Engine oil capacity is the same for both.
• Synthetic vs. conventional: Full synthetic oil is acceptable and often preferred; follow the same viscosity and capacity.
• Service interval: Follow the Maintenance Minder system or, if unavailable, change oil roughly every 5,000–7,500 miles (8,000–12,000 km) depending on driving conditions.

These points don’t change the stated capacity but can improve maintenance outcomes and engine longevity.

Summary

The 2008 Honda CR‑V 2.4L typically requires 4.4 US quarts (4.2 liters) of oil with a filter change and 4.2 US quarts (4.0 liters) without. Use 5W‑20 oil meeting current API standards, torque the drain plug to 29 lb‑ft with a new crush washer, and verify the level on the dipstick after filling to ensure proper lubrication.

How much oil does a 2.4 CR-V take?

The owner’s manual states this car requires 4.7 quarts of oil so I recommend getting at least a 5 quart jug never hurts to get a little bit extra in case you burn some oil in between your oil changes

Can I put 5 quarts of oil in a Honda CR-V?

Up to 5 quarts of oil.

How much oil does a 2.4 L 4 cylinder Honda take?

0W20. This is going to take 4.2 quarts so it’s going to take. Almost this whole jug but not all of it. So I’m going to go for about four quarts.

How many quarts of oil does a 2008 Honda CR-V 2.4 L take?

Engine Oil
Capacity: 4.4 quarts (with filter). After refill check oil level.