How Much Oil a 2017 Audi A4 2.0 Turbo Takes

The 2017 Audi A4 with the 2.0L turbocharged engine typically takes about 5.5 to 6.0 liters (approximately 5.8 to 6.3 US quarts) of engine oil with a filter change, depending on the exact engine variant and how thoroughly the old oil is drained. Below is a detailed breakdown of the capacity, why the range exists, and how to make sure you are filling to the correct level for your specific car.

Official Specifications and Real-World Range

The 2017 Audi A4 2.0 Turbo (B9 generation) uses a 2.0L TFSI four‑cylinder engine. Audi’s official documentation and service data list an oil capacity in the range of roughly 5.7 to 6.0 liters (about 6.0 to 6.3 US quarts) when changing both oil and filter. In practice, many owners and technicians report refilling with around 5.5 to 5.8 liters (5.8 to 6.1 quarts), then topping off to reach the correct level.

Why There Is a Range, Not a Single Number

Oil capacity is often given as a range because real-world conditions affect how much oil actually drains from the engine. Some oil remains inside oil galleries, the turbocharger, and other internal passages, especially if the vehicle is not perfectly level or the oil isn’t fully warmed before draining. This means the refill quantity needed to reach the “full” mark can be slightly less than the absolute system capacity.

Typical Oil Capacity Figures for the 2017 Audi A4 2.0 TFSI

The figures below summarize what owners, independent shops, and service data consistently report for the 2017 Audi A4 2.0 turbocharged engine. This information is intended as a practical reference when planning an oil change, but checking the dipstick or the MMI (if equipped) is always the final authority.

• Estimated refill with filter change: about 5.5–5.8 liters (≈5.8–6.1 US quarts)
• Maximum system capacity (fully drained): roughly 5.7–6.0 liters (≈6.0–6.3 US quarts)
• Typical shop practice: add ~5.5 liters, then adjust in small increments while checking level
• Oil grade: 0W‑20 or 5W‑40/5W‑30 depending on market and spec, always meeting VW 508 00/509 00 or VW 502 00/504 00 (check the owner’s manual for your region)
• Drain plug torque and filter type: vary slightly by engine code; always consult service data

These figures show that, in normal conditions, you will almost never pour a full 6 liters straight in from empty; instead, you approach that number gradually and stop once the correct level is reached.

How to Confirm the Exact Oil Capacity for Your Specific A4

Even within the same model year, there can be slight differences between engine codes, markets (US, EU, etc.), and software revisions. For that reason, it is prudent to confirm the exact specification that applies to your car before performing maintenance.

The following steps explain how owners can verify the recommended oil capacity and specification using official and reliable sources rather than relying on guesswork or conflicting online anecdotes.

1. Check the owner’s manual: Look under “Engine Specifications” or “Capacities” for the oil quantity with and without filter change.
2. Identify your engine code: Common codes for 2017 A4 2.0 TFSI include variants like CNCD/CHHB and others, often listed on a sticker in the trunk, service booklet, or via dealer lookup.
3. Use Audi’s official service data: Dealerships and many independent shops have access to factory data (Elsa/Erwin) listing exact capacities for each engine code.
4. Consult reputable parts catalogs: Some online OEM parts catalogs list oil capacity by VIN or engine code, which can confirm the expected refill amount.
5. Ask a dealer or trusted independent shop: Provide your VIN and request the official oil capacity for an oil-and-filter service.

By following these steps, you ensure that any oil change is based on precise, vehicle-specific data rather than approximate values that might not perfectly match your engine configuration.

Best Practice for Filling: How Much Oil to Pour In

While knowing the capacity range is useful, correct procedure matters more than hitting an exact number. Technicians focus on reaching the proper level, not on blindly matching a textbook capacity figure. The following guidelines describe a safe method to avoid overfilling or underfilling.

1. Warm the engine first: Drive the car until the engine reaches normal operating temperature so the oil drains more completely.
2. Drain thoroughly: With the car safely lifted and leveled, remove the drain plug and allow several minutes for oil to fully drain, then replace the plug with a new washer if required.
3. Replace the oil filter: Fit a new filter, lightly oil the rubber seal if applicable, and tighten to the specified torque or per manufacturer instructions.
4. Add an initial amount: Pour in about 5.0–5.2 liters (around 5.3–5.5 quarts) of fresh oil to start, which is safely below the typical full capacity.
5. Check the level: Start the engine, let it run briefly, then shut it off and wait a few minutes; check the dipstick or MMI display and add oil in small increments (100–200 ml) until the level is just below or at the “max” mark.
6. Recheck after driving: After a short drive and a few minutes of cooling, verify the level again to ensure it remains within the safe range.

This staged approach effectively accounts for small variations in how much oil remained in the engine after draining, ensuring you reach an accurate final level instead of relying solely on a nominal capacity figure.

Oil Type and Specification for the 2017 Audi A4 2.0 Turbo

Capacity is only half of the picture: using the correct specification and viscosity is equally important for protecting the turbocharged engine, especially given long service intervals and high operating temperatures.

The following points highlight what owners should look for when selecting oil for a 2017 A4 2.0 TFSI, with an emphasis on compatibility with Audi’s current standards. Always defer to your vehicle’s specific manual and regional recommendations.

• Audi/VW spec: Look for oils that meet VW 508 00/509 00 (for newer low‑viscosity oils) or VW 502 00/504 00 where specified by Audi for your market.
• Viscosity: Common recommendations include 0W‑20 (in many newer factory specs) or 5W‑40 / 5W‑30 (depending on climate and spec); use what your manual specifies.
• Synthetic oil only: Full synthetic oil is strongly recommended and assumed in factory service intervals.
• Change intervals: Many markets use flexible/long-life intervals up to around 10,000 miles (≈15,000 km) or annually; severe use (short trips, extreme temperatures) may warrant shorter intervals.
• Brand flexibility: Brand is less critical than meeting the exact VW specification and viscosity recommended in the manual.

Focusing on the correct specification rather than brand or marketing terms ensures that the oil can handle the thermal and mechanical demands of the turbocharged engine under typical and severe driving conditions.

Risks of Overfilling or Underfilling

Given the relatively narrow band between “min” and “max” on the dipstick, accuracy matters. Both overfilling and underfilling can have consequences, especially for a modern turbocharged engine like the 2.0 TFSI.

The list below outlines the main risks associated with incorrect oil levels, underscoring why it’s safer to start slightly low and top off than to pour in too much at once.

• Overfilling: Can cause excessive crankcase pressure, aerated (foamy) oil, potential seal leaks, and in extreme cases, catalytic converter or turbo issues from oil being forced into places it shouldn’t go.
• Underfilling: May lead to inadequate lubrication under load, faster oil degradation, higher operating temperatures, and increased wear on bearings, camshafts, and the turbocharger.
• Incorrect spec: Even at the right quantity, the wrong oil specification can affect timing chain tensioners, turbo bearings, and emissions systems.
• Ignoring warning indicators: Continuing to drive with oil level or pressure warnings can rapidly escalate minor issues into major engine damage.

By aiming for the correct level within the marked range and watching for any warning lights or messages, owners can significantly reduce the risk of costly engine repairs related to lubrication problems.

Key Takeaways for 2017 Audi A4 2.0 Turbo Owners

Putting all of this into practical terms, the essential information for an oil change on a 2017 Audi A4 2.0 Turbo can be summarized into a few core points. These points are designed as a quick reference for planning and performing routine maintenance.

• Expect to use around 5.5–5.8 liters (≈5.8–6.1 US quarts) of oil with a filter change in normal conditions.
• The full system capacity can be close to 5.7–6.0 liters (≈6.0–6.3 quarts), but real-world refill is often slightly less.
• Always verify the exact recommendation in your owner’s manual and by engine code or VIN when possible.
• Use full synthetic oil that meets the required VW/Audi specification and viscosity for your region.
• Add oil in stages, checking the level carefully to avoid overfilling and to confirm proper lubrication.

These points provide a concise operational guide: know the approximate capacity, confirm the spec, and rely on measured level checks rather than pouring a fixed number of liters without verification.

Summary

The 2017 Audi A4 2.0 Turbo generally requires about 5.5 to 6.0 liters (roughly 5.8 to 6.3 US quarts) of engine oil when changing both oil and filter, with most real-world refills landing near the 5.5–5.8 liter mark. Variations in how completely the old oil drains mean that capacity is best treated as a guideline rather than a rigid number. The most reliable approach is to consult the owner’s manual and official service data for your specific engine code, then add oil in stages—using the dipstick or MMI oil-level display to confirm the final amount. Combined with the correct VW/Audi oil specification and regular maintenance intervals, this method ensures the 2.0 TFSI engine remains properly protected and performs as intended.

How much oil does a 2017 Audi 2.0 take?

5.5 quarts
Capacity: 5.5 quarts (with filter). After refill check oil level.

What kind of oil does an Audi A4 2.0 turbo take?

Choosing the Best Oil for Your Audi A4
Audi recommends using synthetic oil that meets the VW 502 00 specification. Here are a few top choices: Castrol EDGE 5W-30 Full Synthetic Motor Oil: Known for its exceptional strength under high pressure, this oil provides superior protection and performance for your Audi A4.

How much is a 2017 Audi A4 oil change?

A 2017 Audi A4 oil change can cost anywhere from $80 to over $300, depending on the service provider. Dealerships are typically more expensive, with costs potentially reaching $300 or more, while independent mechanics or quick-lube shops may charge between $80 and $200. Factors influencing the price include the cost of full synthetic oil, labor rates, and location. 
Factors influencing the cost

• Service provider: Dealerships often charge higher labor rates and for OEM parts, leading to a higher total cost. Independent mechanics can be less expensive. 
• Oil type: Audi requires a synthetic oil, which is more costly than conventional oil. 
• Labor costs: Labor rates vary by location and shop. Some estimates suggest a 2017 A4 oil change can take 2-2.5 hours of labor, notes Reddit user. 
• Location: The cost of parts and labor can fluctuate significantly based on your geographic location. 

Average costs by service type

• Dealership: Can range from $250 to $350 or more, as they use official parts and trained technicians. 
• Independent mechanic: Typically ranges from $80 to $200, depending on the shop and parts used. 

How to get the best price

• Check for specials: Dealerships often have coupons or service specials available, so check their websites before you book an appointment.
• Shop around: Call different types of shops, such as independent mechanics and quick-lube services, to compare quotes. 

What oil does a 2017 Audi A4 take?

A 2017 Audi A4 typically requires a full synthetic 5W-40 motor oil that meets Audi’s VW 502 00 specification. You may also be able to use 5W-30 or other approved synthetic oils depending on your climate and specific engine, but always check the owner’s manual to confirm the correct specification for your vehicle. You will need approximately 5.2 to 5.5 quarts. 
Key details

• Recommended viscosity: 5W-40, full synthetic is the most common recommendation. 
• Alternative viscosity: 5W-30 or other suitable synthetic oils can be used if they meet the required Audi/VW standards. 
• Specification: Look for oil that meets the VW 502 00 specification. 
• Capacity: The engine holds about 5.2 to 5.5 quarts of oil. 
• Why synthetic is important: Synthetic oil is recommended for its superior performance and protection, especially for turbocharged engines.