What oil does the 2019 Honda Civic use?

The 2019 Honda Civic is designed for SAE 0W-20 full-synthetic motor oil that meets API SN (or newer SN Plus/SP) and ILSAC GF-5/GF-6 standards; Honda Genuine 0W-20 is the factory recommendation. In practice, every 2019 Civic variant—including the 2.0L, 1.5L turbo, Si, and Type R—uses 0W-20, with oil capacities varying by engine. Below is a breakdown of specifications, capacities, and maintenance guidance to help you choose the right oil and service the car correctly.

Official specification: viscosity and standards

Honda’s engineering and warranty guidance centers on a precise viscosity and quality standard to ensure proper lubrication, fuel economy, and turbocharger protection (where applicable). The following are the key requirements for oil selection.

• Viscosity: SAE 0W-20
• Quality standards: API SN (or newer SN Plus or SP) and ILSAC GF-5 or GF-6A
• Type: Full-synthetic (Honda Genuine 0W-20 is recommended; high-quality equivalents are acceptable)
• Label cues: “Resource Conserving” (SN) or GF-6A marking (SP) on the bottle indicates fuel-saving, low-friction formulation

These specifications are backward-compatible: modern API SP/GF-6A 0W-20 oils exceed the original 2019 requirements and are suitable for all Civic engines that year.

Engine-by-engine oil capacities for the 2019 Civic

While all 2019 Civics use 0W-20, the amount you need depends on the engine. The figures below are approximate refill capacities with a new filter; always finish by checking the dipstick on level ground.

• 2.0L naturally aspirated (LX/EX trims): about 4.4 US qt (4.2 L) with filter
• 1.5L turbo (EX/Touring and most trims): about 3.7 US qt (3.5 L) with filter
• Si (1.5L turbo, high output): about 3.7 US qt (3.5 L) with filter
• Type R (2.0L turbo): about 5.7 US qt (5.4 L) with filter

Treat these as starting points. Add most of the stated capacity, run the engine briefly, then top up to the dipstick’s upper mark. Overfilling can be harmful, especially on turbo engines.

Change intervals and Honda Maintenance Minder

The 2019 Civic uses Honda’s Maintenance Minder to calculate oil life based on temperature, trips, and load. When the system shows 15% oil life, it’s time to plan service; at 5% or lower, change it as soon as possible. Real-world intervals commonly range from 7,500 to 10,000 miles (12,000–16,000 km) or about 12 months under normal driving.

If you drive frequent short trips, tow, idle often, or operate in extreme cold/heat, change oil more often than typical. Turbo models especially benefit from timely changes using API SN Plus or SP oils, which are designed to resist low-speed pre-ignition and protect turbo hardware.

Practical tips, compatibility, and cautions

A few small choices can improve longevity and reduce the risk of issues, especially on turbocharged Civics.

• Stick with 0W-20 year-round unless your owner’s manual specifies otherwise; do not mix viscosities when topping up.
• Choose API SP/GF-6A 0W-20 when possible; it supersedes earlier SN/SN Plus and is fully backward-compatible.
• Use a quality oil filter meeting OEM specs; replace the drain-plug crush washer and torque the plug to about 30 lb-ft (40 N·m).
• After refilling, idle the engine, check for leaks, and verify the level on the dipstick after a few minutes of rest.
• Type R/track use: Honda’s printed spec is still 0W-20. For repeated high-heat track sessions, consult the owner’s manual and Honda performance guidance before deviating; warranty and climate considerations apply.

Following these practices—paired with the Maintenance Minder—helps maintain engine efficiency, control deposits, and protect turbo bearings where fitted.

Bottom line

All 2019 Honda Civics take SAE 0W-20 full-synthetic oil that meets API SN (or newer SN Plus/SP) and ILSAC GF-5/GF-6A. Use Honda Genuine 0W-20 or an equivalent name-brand oil, and follow engine-specific capacities: roughly 3.7 qt for most 1.5T/Si models, 4.4 qt for the 2.0L non-turbo, and 5.7 qt for the Type R. Always confirm on the dipstick and service when the Maintenance Minder advises.

Summary

The 2019 Honda Civic’s factory oil is SAE 0W-20 full-synthetic meeting API SN/SN Plus/SP and ILSAC GF-5/GF-6A. Capacities vary by engine—about 3.7 qt (1.5T/Si), 4.4 qt (2.0L NA), and 5.7 qt (Type R)—and should be verified by dipstick. Choose a quality filter, replace the crush washer, torque the drain plug properly, and follow the Maintenance Minder for change timing.

What oil does a 2019 Honda Civic use?

synthetic 0W-20
Whether you’ve just bought a new Civic or have been driving one for a while, you may wonder, “What oil does a Honda Civic take?” Your Honda Civic requires synthetic 0W-20 rated oil, the standard choice for optimal engine health and improved overall performance.

Does Honda recommend full synthetic oil?

Understanding Honda’s Oil Recommendations
Our service experts are happy to help you select the right oil. Most Hondas from the last decade require synthetic oil due to its high durability and engine protection properties.

Is 5W-30 oil good for Honda Civic?

Both 5w 30 and 5w40 are compatible for the civic fd1 as per the manual.

What kind of oil does a 1.5 L Honda Civic take?

0W-20
Deluxe Oil Change Kit Compatible with Honda Civic 1.5L Turbo 2016-2020, CR-V 1.5L Turbo 2017-2022 0W-20 Full Synthetic – 3.5 Quarts.