What PSI Should Honda Civic Tires Be Set To?

Most Honda Civic models specify about 32 psi (approximately 220 kPa) cold for both front and rear tires on stock sizes, with some trims and wheel packages calling for 33–35 psi (230–240 kPa). For the most accurate figure, check the Tire and Loading Information label on the driver’s door jamb or your owner’s manual.

Where to find the exact recommended pressure

Honda sets tire pressures by trim, wheel size, and tire spec, so the precise number for your Civic is printed on your car. This “cold tire pressure” is the value you should use when the car has been parked for at least three hours and driven less than a mile.

The two authoritative sources are:
– The Tire and Loading Information placard on the driver’s door jamb
– The owner’s manual for your model year and trim

If the tire brand or size has been changed from stock, continue to use the vehicle placard pressure unless instructed otherwise by a qualified tire professional for a specific fitment.

Typical pressures for recent Civics

The following overview summarizes common factory recommendations observed across recent Honda Civic generations. Use it as a quick orientation while you confirm the exact number on your door placard.

• Most Civic Sedan/Hatchback (stock 16–18 inch wheels): commonly 32 psi cold front and rear.
• Sport/Si trims or low-profile factory tires: often 33–35 psi cold.
• Performance variants (e.g., Type R): may specify mid-30s psi; check the placard, as pressures can differ with wheel/tire packages.
• Temporary spare (“donut”): typically 60 psi; this is printed on the spare itself.

Because factory specs can vary by wheel and tire size even within the same model year, always prioritize the figure on your specific vehicle’s door placard over generalized charts.

When and how to check and adjust

Correct readings depend on checking pressures under the right conditions and using a reliable gauge. Follow these steps to measure and set your Civic’s tire pressure accurately.

1. Park the car for at least three hours and ensure tires are cool to the touch (morning is best).
2. Use a quality digital or dial gauge to measure each tire, including the spare.
3. Inflate to the exact psi shown on the driver’s door placard; match front and rear if the placard lists one value for both.
4. If you’ve just driven, add roughly 2–3 psi to account for heat, then re-check when cold and fine-tune.
5. After adjusting pressures on Civics with TPMS, perform a TPMS calibration via the infotainment/vehicle settings (menu wording varies by year) so the system learns the new baseline.

Rechecking after a short drive isn’t necessary if you set pressures cold, but it can confirm that caps are tight and no slow leaks are present.

Seasonal and load considerations

Temperature, elevation, and load affect tire pressure and handling. Keeping these factors in mind helps you stay within safe limits throughout the year.

• Temperature swings: Expect about a 1 psi change for every 10°F (≈6°C) change in ambient temperature; pressures drop in cold weather.
• Long trips or full loads: Most Civics list a single placard value for all normal load conditions; do not exceed the placard unless your manual specifies an alternate “full load” pressure.
• Altitude: Gauge measurements already reflect local atmospheric pressure; no special adjustment is required solely for elevation.
• Aftermarket tires/wheels: Maintain the vehicle’s placard psi unless a tire professional recommends a different setting for the specific tire size and load rating.

If seasonal temperatures vary widely where you live, consider checking pressures monthly and before long drives to keep them at the placard spec.

Common mistakes to avoid

Several frequent missteps can lead to premature tire wear, poor fuel economy, or compromised safety. Keeping clear of these pitfalls will help you get the most from your tires and TPMS system.

• Setting pressure based on the tire sidewall “max” number—this is not the recommended operating pressure.
• Relying on the TPMS warning light as a routine gauge—TPMS warns of significant deviations but doesn’t fine-tune to the exact placard psi.
• Checking pressure after driving and adjusting down—hot tires will read higher; always set pressures cold.
• Forgetting the spare—temporary spares typically need 60 psi and are often neglected.

Following the door placard and checking tires cold with a reliable gauge will prevent most issues and ensure consistent performance and safety.

Bottom line

For most Honda Civics, 32 psi cold is common, with certain trims ranging up to 33–35 psi. Always confirm on your driver’s door placard and set pressures cold. Recalibrate TPMS after adjustments and check monthly, especially with seasonal temperature changes. Keep the temporary spare at its labeled pressure, typically 60 psi.

Summary

Set your Honda Civic’s tires to the cold pressure on the driver’s door placard—commonly around 32 psi, sometimes 33–35 psi depending on trim and wheel size. Measure when tires are cold, adjust with a reliable gauge, recalibrate TPMS if applicable, and check monthly or with major temperature shifts. Use the placard value over the tire’s sidewall maximum, and maintain the temporary spare at its marked pressure.

Is 37 psi tire pressure too high?

Whether 37 psi is too high depends entirely on the recommended pressure for your specific vehicle, which you can find on the sticker inside the driver’s door jamb or in your owner’s manual. 37 psi can be too high if the recommended pressure is, for example, 32 psi, leading to uneven tire wear and reduced traction. However, if your vehicle’s recommended pressure is 36 psi or higher, then 37 psi is a perfectly safe and acceptable pressure to maintain. 
How to determine the correct tire pressure:

1. 1. Find the recommended pressure: . Opens in new tabLook for a sticker on the driver’s side doorjamb or consult your vehicle’s owner’s manual. 
2. 2. Check cold tires: . Opens in new tabThe recommended pressure is for cold tires, meaning they haven’t been driven on for several hours, typically in the morning. 
3. 3. Use a tire pressure gauge: . Opens in new tabInflate or deflate the tires to the pressure listed on the door sticker using a tire pressure gauge. 
4. 4. Consider the temperature: . Opens in new tabIf the temperature has been cold, tire pressure may be lower, and it will increase by a few PSI as the tires warm up during driving. 

Why 37 psi could be too high:

• Uneven wear: Overinflated tires contact the road primarily in the center, causing the middle of the tread to wear out faster. 
• Reduced grip: The smaller contact patch with the road can lead to reduced traction and braking performance. 
• Harsh ride: Overinflated tires provide a harsher, less comfortable ride on bumpy surfaces. 

What is the psi for a 2014 Honda Civic?

The recommended tire pressure for a 2014 Honda Civic is typically 32 PSI for most trim levels, but you should always check the label on the driver’s side doorjamb for the exact specifications for your specific vehicle. Check tire pressure when tires are cold, and after inflating, you may need to perform a TPMS calibration by pressing the MENU button on the steering wheel. 
How to Find Your Exact Tire Pressure

1. Look on the Driver’s Doorjamb: The most accurate tire pressure for your 2014 Honda Civic is listed on the tire and loading information sticker located on the driver’s doorjamb. 
2. Refer to the Owner’s Manual: You can also find this information in your vehicle’s owner’s manual. 

How to Check and Inflate Your Tires

1. 1. Check When Tires Are Cold: Always check tire pressure when the tires are cold, before driving any significant distance. 
2. 2. Use a Tire Pressure Gauge: Use a reliable tire pressure gauge to measure the air pressure in each tire. 
3. 3. Inflate to the Recommended PSI: If the pressure is low, add air until it reaches the PSI listed on the doorjamb sticker. 
4. 4. Calibrate the TPMS (if needed): After inflating, you may need to calibrate the Tire Pressure Monitoring System (TPMS). 
   • Press the MENU button on the steering wheel. 
   • Select Customize Settings, then TPMS Calibration. 
   • Select Initialize and then Yes. The system will calibrate automatically during a short drive. 

What psi should my tires be on a Honda Civic?

For most Honda Civic models, the recommended tire pressure is 32 PSI (pounds per square inch). However, it’s always best to check the specific recommendation for your particular Civic model, which you can find on a sticker inside the driver’s side doorjamb or in your owner’s manual, according to Honda dealerships. 
Here’s why:

• Vehicle Specific: . Opens in new tabDifferent car models, even within the Honda Civic lineup, may have slightly different optimal tire pressures, according to Patty Peck Honda. 
• Owner’s Manual and Door Jamb Sticker: . Opens in new tabThese are the definitive sources for your specific vehicle’s recommended tire pressure. 
• Cold Tire Pressure: . Opens in new tabThe recommended pressure is for “cold” tires, meaning tires that haven’t been driven on for a few hours and haven’t heated up from use. 
• Tire Pressure Monitoring System (TPMS): . Opens in new tabIf your car has a TPMS, it will alert you if the tire pressure is significantly low. However, it’s still a good idea to manually check and adjust your tire pressure regularly, recommends Reddit user. 

Is 35 psi too high?

No, 35 PSI is not too high for most car tires. It’s a common recommended tire pressure, especially for passenger cars. The ideal tire pressure for your vehicle can be found on a sticker inside the driver’s side doorjamb or in the owner’s manual. 
Here’s why 35 PSI is often a good target:

• Standard recommendation: Many vehicles have a recommended tire pressure of 32-35 PSI. 
• Even tire wear: Maintaining the correct pressure helps tires wear evenly, maximizing their lifespan and performance. 
• Optimal handling and fuel efficiency: Proper inflation contributes to better handling, improved gas mileage, and a smoother ride. 
• Safety: Underinflated tires can lead to blowouts, while overinflated tires can result in a harsher ride and reduced traction. 

Important considerations:

• Consult your vehicle’s specifications: . Opens in new tabAlways refer to your vehicle’s owner’s manual or the sticker on the driver’s side doorjamb for the specific recommended tire pressure for your car. 
• Tire pressure increases when tires heat up: . Opens in new tabCheck tire pressure when the tires are cold, as heat from driving can cause the pressure to increase. 
• Don’t exceed maximum inflation pressure: . Opens in new tabThe maximum pressure listed on the tire sidewall is not the recommended pressure for your vehicle, but rather the maximum the tire can safely hold.